As part of our daily life saving equipment is often used to Changzhou particle machine has easy operation, saving time and effort, and other advantages. So it's a combination of the basic structure but also which parts can be made of it? Here you details of the basic structure of Changzhou particle machine: 1, the main body: the body is an independent rectangular cylinder, closed on devices connected to the bearing housing with powder hopper, powder hopper toward the outside of the body, under which is equipped with V shaped chassis, the wide and flat ground, so the next to be installed, can be any place for indoor use. 2, particle manufacturing apparatus: a rotating drum set lying below the powder hopper, front and rear bearing supports, through a rack of gear, as inverted rotation, the end face of the front bearing cover for the movable assembly and disassembly, as long as spin Under a wing nut, bearing cap and the rotating drum to be pulled out, placed at both ends of the system has a convex side of the drum loop, insert bearing interior, so do not make the oil penetrate the powder and not plugged bond. 3, gear box: The worm gear, ratio to 1:12, oil storage tank can ensure good gear lubrication and no noise, there can be observed depending on the mirror box, observe the functioning and oil reserves, the outer end of the worm gear, equipped with eccentric shaft, the rack drive reciprocates. 4. Pinch the screen: device rotating drum lined with steel pipe manufacturing, has opened in the middle of a long trough, both ends of the mesh into the trench, flower-shaped hand wheel will rotate the screen on the outer package rotating drum, handwheel gear shore, tightness can be adjusted. 5, the motor frame: a screw bolt jail, the motor is mounted on the plate, when the rotation of the screw bolt, on the up and down movement of the motor for adjusting the belt. Ring die pellet mill Changzhou, Changzhou particle machine accessories www.rtjxjg.com